projets:fuz:webduino
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projets:fuz:webduino [2019-12-03 21:39] – [Photocell] document photocell reading with example sketch Lomanic | projets:fuz:webduino [2019-12-04 01:39] – [RGB LED] Lomanic | ||
---|---|---|---|
Line 12: | Line 12: | ||
* [[https:// | * [[https:// | ||
* Webduino USB port is only used to power the board, not for upload and monitoring | * Webduino USB port is only used to power the board, not for upload and monitoring | ||
- | * The chip is labeled ESP8266MOD by AI Thinker, in fact it is an ESP-12F, same as Wemos d1 | + | * The chip is labeled ESP8266MOD by AI Thinker, in fact it is an ESP-12F, same as Wemos D1 |
- | * The Board include | + | * The board includes |
* [[https:// | * [[https:// | ||
Line 91: | Line 91: | ||
RGB_color(255, | RGB_color(255, | ||
break; | break; | ||
- | case 3: // CYAN | + | case 3: |
RGB_color(0, | RGB_color(0, | ||
break; | break; | ||
- | case 4: // BLUE? | + | case 4: |
RGB_color(255, | RGB_color(255, | ||
break; | break; | ||
- | case 5: // GREEN | + | case 5: |
RGB_color(255, | RGB_color(255, | ||
break; | break; | ||
Line 154: | Line 154: | ||
void loop() { | void loop() { | ||
if (digitalRead(GPIO_MICRO_SWITCH_BUTTON) == LOW) { | if (digitalRead(GPIO_MICRO_SWITCH_BUTTON) == LOW) { | ||
- | Serial.println(analogRead(GPIO_PHOTOCELL)); | + | Serial.println(analogRead(GPIO_PHOTOCELL)); |
} | } | ||
} | } |
projets/fuz/webduino.txt · Last modified: 2023-02-02 22:06 by 127.0.0.1