projets:fuz:webduino
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projets:fuz:webduino [2019-11-30 23:39] – [OTA] Lomanic | projets:fuz:webduino [2019-11-30 23:49] – [Description] link to programmersought.com Lomanic | ||
---|---|---|---|
Line 12: | Line 12: | ||
* [[https:// | * [[https:// | ||
* Webduino USB port is only used to power the board, not for upload and monitoring | * Webduino USB port is only used to power the board, not for upload and monitoring | ||
- | * The chip is labelled | + | * The chip is labeled |
* The Board include a photocell, a RGB led and a button. | * The Board include a photocell, a RGB led and a button. | ||
+ | * [[https:// | ||
===== Wiring and flashing ===== | ===== Wiring and flashing ===== | ||
- | Plug Webduino Smart using FTDI **3.3v** module. Webduino and the FTDI must be powered. | + | Plug Webduino Smart using FTDI **3.3v** module. Webduino and the FTDI must be powered. Webduino is powered through its micro USB port. |
- | 3.3 3.3 | + | |
- | ftdi Tx | + | |
- | | + | |
| | ||
Line 32: | Line 32: | ||
- Set flash position (GPIO0 on GND) | - Set flash position (GPIO0 on GND) | ||
- Power the FTDI and the Webduino | - Power the FTDI and the Webduino | ||
- | - Upload sketch ... Webduino should restart in normal mode. | + | - Upload sketch... Webduino should restart in normal mode. |
- | - Or disconnect GPIO 0 and restarrt | + | - Or disconnect GPIO 0 and restart |
===== Arduino IDE ===== | ===== Arduino IDE ===== |
projets/fuz/webduino.txt · Last modified: 2023-02-02 22:06 by 127.0.0.1