projets:fuz:webduino
This is an old revision of the document!
Table of Contents
Webduino Smart
Goals
- [OK] Flash Webduino with different IDEs
- Check Components : pins, photocell, RGB LED, button
- Use OTA
Description
- Webduino USB port is only used to power the board, not for upload and monitoring
- The chip is labeled ESP8266MOD by AI Thinker, in fact it is an ESP-12F, same as Wemos d1
- The Board include a photocell, a RGB led and a button.
- Unofficial tutorial in ~english, with how to flash webduino with FTDI
Wiring and flashing
Plug Webduino Smart using FTDI 3.3v module. Webduino and the FTDI must be powered. Webduino is powered through its micro USB port.
Tx Rx ftdi Rx Tx Webduino Gnd Gnd
For flashing, on Webduino Smart connect GPIO 0 to GND. (RGB goes green)
For rebooting, on Webduino Smart connect RST to GND
Flashing usual sequence is :
- Set flash position (GPIO0 on GND)
- Power the FTDI and the Webduino
- Upload sketch… Webduino should restart in normal mode.
- Or disconnect GPIO 0 and restart using RST or Webduino power
Arduino IDE
Select Board : “Generic ESP8266 Module”
Platformio
Got it to work as a Wemos d1 !
[env:d1] platform = espressif8266 board = d1 framework = arduino
Components
I got blink sketch using LED_BUILTIN (2)
OTA
projets/fuz/webduino.1575157759.txt.gz · Last modified: 2023-02-02 22:06 (external edit)