projets:fuz:webduino
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| projets:fuz:webduino [2020-09-19 23:36] – [Description] +Witty Cloud Lomanic | projets:fuz:webduino [2023-02-02 22:06] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| <WRAP round box 60%> | <WRAP round box 60%> | ||
| ===== Goals ===== | ===== Goals ===== | ||
| - | * [OK] Flash Webduino with different IDEs | + | * [OK] Flash Webduino |
| * [OK] Check Components : pins, photocell, RGB LED, button | * [OK] Check Components : pins, photocell, RGB LED, button | ||
| * [OK?] Use OTA | * [OK?] Use OTA | ||
| Line 20: | Line 20: | ||
| ===== Wiring and flashing ===== | ===== Wiring and flashing ===== | ||
| - | Plug Webduino Smart using FTDI **3.3v** module. Webduino and the FTDI must be powered. Webduino is powered through its micro USB port. | + | Plug the Webduino Smart using an FTDI **3.3v** module. |
| | | ||
| Line 36: | Line 36: | ||
| - Power the FTDI and the Webduino | - Power the FTDI and the Webduino | ||
| - (RGB goes light blue) Disconnect GPIO 0 | - (RGB goes light blue) Disconnect GPIO 0 | ||
| - | - Upload sketch... Webduino should restart in normal mode. | + | - Upload sketch... Webduino |
| - | - Or disconnect GPIO 0 and restart using RST or Webduino power | + | - Or disconnect GPIO 0 and restart using RST or Webduino |
| ===== Arduino IDE ===== | ===== Arduino IDE ===== | ||
projets/fuz/webduino.txt · Last modified: 2023-02-02 22:06 by 127.0.0.1