Differences

This shows you the differences between two versions of the page.

--- projets:fuz:webduino [2019-11-30 23:39] – [OTA] Lomanic
+++ projets:fuz:webduino [2019-11-30 23:41] – [Wiring and flashing] Lomanic
@@ Line 18: / Line 18: @@
 ===== Wiring and flashing =====
-Plug Webduino Smart using FTDI **3.3v** module. Webduino and the FTDI must be powered.
+Plug Webduino Smart using FTDI **3.3v** module. Webduino and the FTDI must be powered. Webduino is powered through its micro USB port.
-.3    3.3
+           Tx     Rx
-    ftdi   Tx     Rx    Webduino
+  ftdi     Rx     Tx     Webduino
-           Rx     Tx
            Gnd    Gnd
@@ Line 32: / Line 31: @@
   - Set flash position (GPIO0 on GND)
   - Power the FTDI and the Webduino
-  - Upload sketch ... Webduino should restart in normal mode.
+  - Upload sketch... Webduino should restart in normal mode.
-  - Or disconnect GPIO 0 and restarrt using RST or Webduino power
+  - Or disconnect GPIO 0 and restart using RST or Webduino power
 ===== Arduino IDE =====