projets:fuz:presence_button
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| projets:fuz:presence_button [2020-10-11 21:18] – [Current status] update all of this with current state and architecture Lomanic | projets:fuz:presence_button [2020-10-12 21:36] – [Hardware] add link to S20 homepage on sonoff.tech Lomanic | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ===== Hardware ===== | ===== Hardware ===== | ||
| - | * some glorious esp8266 in a Sonoff S20 power plug (NodeMCU v0.9 for development) | + | * some glorious esp8266 in a [[https:// |
| To flash a Sonoff S20, solder the pins on the left of the push button, connect your USB-to-Serial convertor (RobotDyn CH340G in this case) to the headers like in the image below (from top to bottom, GND, TX, RX, 3.3v VCC), push Sonoff button while plugging in your USB-to-Serial convertor in your PC and then release the push button after a few seconds (check out [[https:// | To flash a Sonoff S20, solder the pins on the left of the push button, connect your USB-to-Serial convertor (RobotDyn CH340G in this case) to the headers like in the image below (from top to bottom, GND, TX, RX, 3.3v VCC), push Sonoff button while plugging in your USB-to-Serial convertor in your PC and then release the push button after a few seconds (check out [[https:// | ||
projets/fuz/presence_button.txt · Last modified: 2023-02-02 22:06 by 127.0.0.1